Receiver Operation - Kenwood TS-790A Instruction Manual

4-2. RECEIVER OPERATION
Different MAIN and SUB band frequencies can be
received simultaneously. Reduce the audio of the band
you do not want to hear. You can turn off SUB-band
audio, if you do not need it, with the BAND switch.
{See 4-2-7. Band switch).A beep will follow pressing
any key.
4-2-1. Receiving
SUB AF trol
pak 1. Connect the power supply and the antenna, and
POWER switch * SUB SQL
MAIN AF contro! sahivel then set the switches and controls as follows:
MAIN SQL controt
POWER switch : OFF ( }
POWER switch of the DC power supply
(Fixed Station) : OFF ( @}
MAIN}SQL control — : Fully counterclockwise
SUB} SQL control : Fully counterclockwise
MAIN] AF control : Fully counterclockwise
| (SUB) AF control : Fully counterclockwise
144ATT switch RIT control : Center
aaa swetch IF SHIFT controi : Center
. Turn on the DC power supply and then turn the
transceiver's power switch ON. The display panel
will indicate as shown below.
[sue ax oisriay
{With the TS-790E)
SUB AX DISPLAY
' nnn
cw (448 EE.
auTd cw
AUTO
Co =
uy
S35
C3 cy
co
cy
Note: van
If the display is not as shown reset the microproces-
sor using the procedure in Section 4-4-2.
SUB AF control
3. Turn the AF control clockwise until a signal or noise
is heard.
MAIN AF control
26