Table of Contents
Advertisement
9.
Run the $trust <MAC address of bluetooth keyboard> command to turst the Bluetooth keyboard.
10.
Run the $connect <MAC address of bluetooth keyboard> command to connect the to the Bluetooth keyboard.
11.
Run the $quit command to quit the bluetoothctl console.
Network Manager – Ubuntu Core 16
Network-Manager is a native Ubuntu Snappy Connection Manager, the application handles multiple network devices, provides
detection and configuration for the system to automatically connect to the network.
A command line utility nmcli is included with Network-Manager to support non-graphical user interface.
NOTE: For more information about Network-Manager, see
Connecting through WWAN
NOTE: For more information on configuring and connecting through WWAN, see
stacks/network/network-manager/docs/configure-cellular-connections.
1.
Check if a modem is present and identify the modem index number.
$ sudo modem-manager.mmcli –L
2.
Check the modem status and identify the primary port.
$ sudo modem-manager.mmcli -m <x>
<x> refers to the modem index number. Replace <x> with the actual modem index after running the
NOTE:
command at step 1.
3.
Create a profile.
$ sudo network-manager.nmcli c add con-name test type gsm ifname <primary port> apn
internet
NOTE: Depending on the return results from step 2, replace
port name.
4.
Check the WWAN status.
$ network-manager.nmcli r wwan
5.
Turn on WWAN.
$ sudo network-manager.nmcli r wwan on
6.
Find wwan0 in the interface list.
$ ifconfig -a
7.
Enable the connection profile.
$ sudo network-manager.nmcli c up test
8.
Check the Network Manager status.
$ network-manager.nmcli d
9.
Disable the connection profile.
$ sudo network-manager.nmcli c down test
10.
Check the Network Manager status.
$ network-manager.nmcli d
Connecting through WLAN
1.
Run the command to show a list of network interfaces like eth0, eth1, wlan0, mlan0, and so on:
$ network-manager.nmcli d
2.
Run the command to show a list of network interfaces like eth0, eth1, wlan0, mlan0, and so on:
$ network-manager.nmcli d
3.
Run the command to show a list of available wireless access points.
$ network-manager.nmcli device wifi list
4.
Wireless connection with nmcli: Run the following commands and replace $SSID, $PSK, and $WIFI_INTERFACE of your
environment.
44
https://wiki.archlinux.org/index.php/NetworkManager
https://docs.ubuntu.com/core/en/
<primary port > after ifname with the actual primary
Advertisement
Table of Contents
