Advertisement
5.2 Assembly Procedures:
Place a bracket chassis base on a protective
S1
cushion, then stick 7pcs Silicon sheets on the
positions as the picture below shown.
Turn over a power board and put the power board
S2
into the bracket chassis, settle the panel power
cable to the correct position.
Take 1pcs interface board, connect 2pcs LVDS cable
to the connectors of the interface board, then connect
the cable of the power board to the connector of the
interface board. Turn over the interface board and
S3
locate it into the main chassis. Use a Philips-head
screwdriver to tighten 8pcs screws for locking the
interface board and power board.
(No.1 screw size=M4x8, Torque=7.5
No.2~8 screw size=M4x8, Torque=7.5
7
5. Disassembly and Assembly Procedures
kgfxcm;
±0.5
kgfxcm)
±0.5
4
8
2
6
1
5
3
Turn over the bracket chassis, and then take 1pcs
S4
black mylar to insert the hooks of the bracket
chassis to cover the power board.
Panel preparation: Take out 1pcs panel module from
the carton, remove the protective film by tearing off
S5
the tapes, then Examine the panel surface
according to inspection criteria. Turn over the panel
to place screen faced down for later assembling.
Take1pcs touch board,1pcs key cable and 1pcs front
bezel, then connect the key cable to the connector
of the board. Tear off the release paper and paste
the touch board on the correct position of the front
S6
bezel, then paste 1pcs mylar to cover the touch
board. Move the front bezel close to the panel
module, then assemble the front bezel with the panel
module.
Advertisement
