Advertisement
Take 1pcs camera unit assembled in LCM line, then
S11
locate the camera unit into the pins of the middle
frame.
Move the bracket and put it on the back of panel,
S12
then connect the 2pcs LVDS cables to the
connectors of the panel module.
Use a Philips-head screwdriver to tighten 4pcs screws
for locking the bracket with the panel, then take 1pcs
S13
camera cable to connect camera with main board.
(No.1~4 Screw size= M3x4, Torque=5±1kgfxcm )
2
5. Disassembly and Assembly Procedures
3
1
4
Use a Philips-head screwdriver to tighten 4pcs
screws for locking the camera unit with the middle
S14
frame.
(No.1~4 Screw size= M3x8, Torque=6±0.5kgfxcm)
3
1
Use a Philips-head screwdriver to tighten 2pcs
screws for locking the middle frame with panel
S15
module and front bezel.
(No.1~2screw size=M2x3.3,Torque=1
2
Take 1pcs USB board, 2pcs connective cables and
1pcs conductive foam. Connect the 2pcs cables to
S16
the connectors of the USB board, then turn over the
board and paste the conductive foam on the back of
the USB board as the picture below shown.
4
2
0.2kgfxcm)
±
1
Advertisement
