Advertisement
Take 1pcs left Mic board,1pcs right Mic board and
some essential cables, then assemble 1pcs rubber
S7
with left Mic board and assemble 1pcs rubber with
right Mic board, then connect left Mic board right Mic
board with cables as the picture below shown.
rubber
5. Disassembly and Assembly Procedures
rubber
Take 1pcs middle frame with speaker cover, then put
the middle frame and locate the Mic boards to the
correct positions, then use a Philips-head screwdriver
S8
to lock 4pcs screws for locking the left and right Mic
boards as the picture below shown.
(No.1~4 screw size=M2x3.3,Torque=1
Tear off the release paper on the back of the touch
cable and then fix the cable on the back of the panel.
S9
Move the middle frame with Mic boards close to the
panel unit, then assemble the middle bezel unit with
the front bezel and panel module.
Use a Philips-head screwdriver to lock 13pcs screws
for locking the middle frame unit with the panel, then
S10
paste 2pcs aluminum foil to fix the Mic board.
(No.1~13 screw size=M3x4,Torque=3
12
6
4
10
2
11
0.2kgfxcm)
±
3
1
4
2
0.5kgfxcm)
±
1
5
7
13
8
3
9
Advertisement
