Advertisement
Locate the USB board into the hook of the middle
frame. Use a Philips-head screwdriver to tighten
1pcs screw for locking the USB unit with the middle
S17
frame, then connect the two USB cables to the
connectors of main board, then fix the cable with
1pcs aluminum foil as the picture below shown.
(No.1 screw size=M3x3.5, Torque=4 0.5 kgfxcm)
Take 1pcs panel lamp cable to connect the main
board with panel, then fix the lamp cable on the back
S18
of the panel with tape. Connect the camera cable to
the connector of the main board.
Take a pair of speakers to locate the probers, then
Use a Philips-head screwdriver to tighten 6pcs
screws for locking the two speakers with the middle
S19
frame, and then connect the speaker's cable to the
connector of the main board and fix the cables and
with 3pcs acetate tape as the picture below.
(No.1~6 Screw size= M3x6, Torque=4~5kgfxcm)
2
3
1
5. Disassembly and Assembly Procedures
±
1
6
5
4
connect the touch cable to the connector of the
interface board, then paste 2pcs aluminum foil on
S20
the specific positions for fixing the bracket and panel
connectors as the picture below shown.
Take 1pcs joystick key, 1pcs joystick board and 1pcs
key cable, then assemble the joystick key with board
S21
and connect the key cable to the connector of the
key board.
Locate the joystick board to the correct position of
the rear cover, then use a Philips-head screwdriver
to tighten 3pcs screws for locking the joystick board
S22
with rear cover, fix the key cable on the rear cover by
3pcs adhesive tapes on the back of the cable.
(No.1~2 screw size=M2x3.3,Torque=1±0.2kgfxcm)
1
2
3
Advertisement
