Entering Test Mode - Motorola iDEN i930 Field Service Manual

Table 6-1. Display Screens (Continued)
Name
IMEI/SIM ID
Registration Log
Err/Channel
Current Freq
Dispatch IDs
Band Info
Bandmap
Hardware
Fatal Err/#
ER Log:
Resets:
Coin Cell
6.1.3

Entering Test Mode

Use this procedure to access Test Mode.
To enter Test Mode:
1. Power up the unit. Wait until the power-up sequence is complete before continuing.
NOTE: Steps 2 through 7 must be performed quickly with no more than one second between each
key press (note: B is the Back key): (#, *, B, B, B, <, B, B, <)
#
2. Press .
*
3. Press .
4. Press the Back key three times.
68P80401P03-O
BASIC LEVEL TEST MODES AND PROCEDURES: Test Modes
Description
Displays the electronic serial number and the SIM ID serial number.
The IMEI is the global name assigned to the mobile station at manufacturing time and should
correspond to the serial-number tag of the unit.
The SIM ID is the SIM electronic serial number and should correspond with the number
stamped on the SIM card.
Pressing OK allows the IMEI/SIM ID to be traced.
Displays the Dispatch Log, Interconnect Log, Packet Data Log, Mobile IP Log, and Phone
Rst Log. Registration Log information is updated when the user deselects and selects the
Registration Log choice.
Displays the physical channel that the unit is connected to or the radio link procedure that is
currently active. Also, displays error codes encountered during normal operation if Err/
Channel is On. At power up, Err/Channel is Off.
Displays current frequency and band. Pressing OK allows the current frequency and band to
be traced.
Displays the Dispatch Group ID affiliated with the unit in the current dispatch-location area.
Also, displays the Dispatch Individual ID affiliated with the unit in the current dispatch
location. Pressing OK allows the dispatch IDs to be displayed periodically.
Displays primary and secondary bands.
Displays the currently selected regional bandmap. Pressing OK allows the bandmap to be
displayed periodically.
Displays the AFC Offset and Channel Number.
Pressing OK allows the hardware parameters to be traced.
Displays the Fatal Error log. This log contains a count of any fatal errors logged during the
unit's automatic self test. Optioning clear empties the log.
Displays the error log. This log contains any errors logged by the unit software.
Displays the Reset Error log. This log contains any errors logged when the user resets the
unit during operation. The most recent reset appears at the top of the list. Pressing Menu
when it appears displays the Clearall screen in which the user can clear all the logged errors.
Displays the Preset Charging Voltage on line 1 and Current Battery Voltage on line 2.
6-3