Wiring - Mitsubishi Electric 800 Series Instruction Manual

2.3

Wiring

1.
Wire the shielded twisted pair cable after stripping its sheath to make its cables loose.
Also, protect the shielded cable of the shielded twisted pair cable to ensure that it will not make contact with the
conductive area.
Shield
(perform protective treatment)
Sheath
Shielded twisted pair cable
Strip the wires as follows. If too much of the wire is stripped, a short circuit may occur with neighboring wires. If not
enough of the wire is stripped, wires may become loose and fall out.
Twist the stripped end of wires to prevent them from fraying. Do not solder them.
16
INSTALLATION AND WIRING
Wire strip length
5mm