Table of Contents
Advertisement
T
SCSI device — The last SCSI device connected to the
system (internally or externally) must have a termination
resistor, either installed manually or set automatically if
the device is self-terminating. Most SCSI devices are
self-terminating. Check the manufacturer's
documentation.
T
Installation hardware — check to be certain you have
the screws necessary to secure the drive in an accessible
drive slot.
Device Cables
The cables used for the installation of optional storage
devices include:
T
diskette drive signal cable
T
IDE signal cable
T
system power cables.
Cable connector locations are shown in the system board
figure in Appendix D.
5-20 Installing Options
The standard IDE hard disk is set as the master
device on the primary IDE connector. The standard
CD-ROM reader is the master device on the
secondary IDE connector.
Advertisement
Table of Contents
