Table of Contents
Advertisement
Press the board firmly into the expansion slot connector.
5.
Gently rock the board from side-to-side to seat it into the
connector.
6.
Insert the screw removed in step 3 to secure the
expansion board to the support bracket.
7. Attach any cables required by the expansion board.
Replace the access cover (see "Replacing the Access
8.
Cover").
Removing an Expansion Board
Follow these steps to remove a board.
Remove the access cover (see "Removing the Access
1.
Cover).
Label and remove any cables connected to the board.
2.
Remove the screw that secures the board to the support
3.
bracket.
4. Pull the board out of the connector. Gently rock the
board from side-to-side to release it from its connector.
5.
Replace the access cover (see "Replacing the Access
Cover).
DIMM UPGRADE
Your system comes factory-installed with 32 MB to 192
MB of main system memory,as three 168-pin sockets on the
system board for Dual In-line Memory Modules (DIMMs).
You may install memory in one, two, or three sockets and
the size and speed of the DIMMs may vary between
sockets. Single- and double-sided DIMMs are supported.
Before installing memory, read the detailed explanation of
memory types and configuration options in Appendix C.
5-12 Installing Options
Advertisement
Table of Contents
