Table of Contents
Advertisement
Diskette Drive Signal Cable
A two-connector diskette drive signal cable comes attached
to the system board and to the standard 1.44-MB diskette
drive. If your system comes standard with an Iomega Ditto
tape backup unit, the signal cable has three connectors.
Depending on your system, installation of a second diskette
drive may require the replacement of the existing diskette
drive signal cable with a three-connector cable. Connect an
optional diskette drive to the middle connector on the three-
connector diskette drive signal cable.
The colored edge of the cable goes to pin 1 on the cable
connector. Align the red edge of the cable with pin 1 (the
notched end) on the drive connector.
The following figure shows a three-connector diskette drive
signal cable.
Optional diskette drive signal cable
Installing Options 5-21
Advertisement
Table of Contents
