NEC VERSA DOCK Manual page 43

The utility checks the currently installed BIOS version and the
diskette's BIOS version. The Main menu appears.
4. Use the arrow keys to highlight the "Display BIOS Version" option
on the Main menu. Use this option to check the currently installed
BIOS version and the version of the new replacement BIOS.
5. Highlight the "Install New BIOS" option and press Enter.
6. Press Y and then press Enter. The update process begins. Finally, a
message appears telling you to remove the diskette in drive A.
7. Remove the diskette and press any key to continue. The utility
updates the BIOS.
Power off your computer. The next time you power on your
computer, you will have the latest NEC Versa LX or SX computer
BIOS revision level.
The following message appears also.
Follow these steps to configure the system's default settings.
1. Press
2. Move the cursor down to highlight Auto Configuration with
Defaults.
3. Press
The message "Load default configuration settings?" displays.
4. Enter
5. Press
You are now ready to resume system operation.
3-4 Setting Up the Software
Wait...
CMOS Checksum Bad
Press F1 to run Setup
F1 to enter the Setup program.
Enter .
Y , then press Enter
, then press
F10
.
to save the default configuration settings.
Enter