Parallel Devices - NEC VERSA DOCK Manual

5. Connect the monitor power cable and plug it into a properly
grounded wall outlet.
6. Follow any setup instructions in the monitor's user's guide.
7. Power on the monitor.
8. Power on the NEC Versa.
Press Fn-F3 to toggle between the LCD, CRT, simultaneous CRT/LCD
display, and TV Out (on systems that support TV Out).

Parallel Devices

To install a parallel device such as a printer, you need a cable with a
male 25-pin connector for the system and, for most parallel printers, a
Centronics®-compatible 36-pin connector.
Connect a parallel device to the NEC Versa Dock as follows.
1. Check that both NEC Versa and the parallel device power are off.
Connecting a monitor cable
Note: When you connect a printer, be sure to
install the appropriate printer driver through the
Windows Control Panel.
Installing Options and Connecting Devices 4-29