NEC VERSA DOCK Manual page 55

2. Locate the power cable and IDE signal cable port, and if necessary,
the audio cable port on the back of the IDE device.
Locating and connecting the cables to the IDE device
A - Audio cable port B - IDE signal cable port C - Power cable port
D - Power cable E - IDE signal cable F- Audio cable
3. Connect the appropriate power cable, the IDE signal cable, and if
necessary the audio cable to the ports on the back of the IDE device.
The IDE cable must be installed with the red stripe to the left side of
the device.
4. Ensure that the IDE connector pin is oriented correctly on the IDE
signal cable.
installing uses a small connector, use one of the
cables provided in the accessory kit.
You are now ready to install the IDE device into the file bay. (See the
instructions in "File Bay Installation" for details.)
Note: If the power cable for the device you are
Installing Options and Connecting Devices 4-9