NOTE:
The replacement drive is automatically configured to RAID 1; no administrator action is
required.
DVD-CD Drive
CAUTION:
all bays are populated with either a component or a blank.
1.
Power off the node.
NOTE:
it may be helpful to use a small, flat, blunt object, such as a key or pen, to push the ejector
button.
2.
Press the ejector button in firmly until the DVD-CD drive ejects (1).
3.
Pull the DVD-CD drive out of the node (2).
To replace the component:
1.
Carefully align the connector on the rear of the drive with the connector on the DVD-CD drive
interface board.
2.
Slide the drive into the bay until it clicks.
158 Component Replacement
To prevent improper cooling and thermal damage, do not operate the node unless
The ejector button for the CD-ROM drive is recessed to prevent accidental ejection;