Opening A Secure Shell Session; Closing A Secure Shell Session; Opening A Serial Session; Closing A Serial Session - HP 12000 User Manual

A secure shell or serial session provides the following:
Setting the VLS network settings
Configuration and management of VLS virtual devices (libraries and tape drives) and cartridges
Changing of the default Fibre Channel host port settings
Viewing and deleting VLS notification alerts
Configuring VLS mail and SNMP notification alert settings
Editing VLS account passwords
Enabling and disabling storage capacity oversubscription
Viewing VLS hardware status
Saving and restoring VLS network settings and virtual library configurations
Restarting VLS device emulations and Command View VLS
Rebooting and powering off the VLS
The serial user interface also provides emergency login access that allows you to change the
administrator password if it is forgotten.

Opening a Secure Shell Session

NOTE: Before you can open a secure shell session, you must set the VLS network settings. See
"Setting the Network Settings" (page
To open a secure shell session:
1. Open a secure shell session to the VLS using a secure shell program (such as PuTTY) or by
entering:
ssh <fully qualified VLS name> and then press Enter.
2. At the Login as: prompt, enter administrator and then press Enter.
3. At the Password: prompt, enter the administrator password and then press Enter.
The default administrator password is admin.

Closing a Secure Shell Session

To close a secure shell session enter logout, done, quit, bye, or exit, and then press Enter.

Opening a Serial Session

To open a serial session:
1. Connect a PC or workstation to the serial port on the rear of the VLS using the null-modem
(serial) cable provided.
2. Establish a CLI session using a terminal emulation program, such as Windows Hyperterminal.
3. Enter administrator or emergency for username. Both logins gives you full privileges to
all VLS functions available through the CLI command set.
4. Enter the administrator or emergency password.
The default administrator password is admin. The emergency password is repair.

Closing a Serial Session

To close a serial session, click Logout at the top of the Console Manager window. This logs you
out of the Console Manager and displays the Logon window.
82 User Interfaces
83).