Setting The Network Settings Using The Cli Command Set - HP 12000 User Manual

6. Enter an IP address in the IP Address box.
7. Enter the subnet mask in the Subnet Mask box.
NOTE:
for the VLS, open a DOS window on the computer running the VLS discovery utility and type
ipconfig /all
8. Enter the gateway in the Gateway box.
9. Enter the DNS server IP address in the DNS IP Address box.
10. Enter the domain name in the Domain Name box.
1 1. Click Configure to save the network settings to the VLS.
12. Click Exit to close the VLS discovery utility.

Setting the Network Settings using the CLI Command Set

To set the network settings using the CLI command set, set either the:
DHCP usage and host name, or
Fully qualified host name (or host name and DNS domain name separately), DNS server
address, IP address, gateway, and netmask
To set the network settings using the CLI command set:
1. Open a serial session and log in to the administrator account. See
Session" (page
2. To see the current configuration settings, at the prompt enter:
showConfig
3. Set each desired configuration value by entering:
setConfigValue <-tag> [value]
where <-tag> can be any of the following:
Tag
-host
-domain
-fullhost
-dnsaddr
-dnsaddr1
-dnsaddr2
-dhcp
-ipaddr
-gate
-mask
ntpPrimary
—ntpSecondary
To display the correct subnet mask, gateway, DNS server, and domain name settings
82).
Description
Host name (such as vlsexamp) (unqualified)
DNS domain name (such as xyz.com)
Fully qualified name (such as vlsexamp.xyz.com)
DNS server address (replaces all addresses with one line)
First DNS server address (cannot use with dnsaddr)
Second DNS server address (cannot use with dnsaddr)
Has no value, indicates you want to configure the public Ethernet connection using
DHCP (reset is -dhcp=false)
IP address of public Ethernet connection
Gateway to network (xx.xx.xx.x)
Netmask. Default is 255.255.255.0
First NTP Server Address
Second NTP Server Address
"Opening a Serial
Setting the Network Settings 85