HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 125

13
NETWORK
RECONFIG- MUST
REBOOT
15
CONFIGURATION
ERROR
16
NOT CONFIGURED
17
UNABLE TO FIND
SERVER
18
PASSWORD ERROR
19
NO QUEUE
ASSIGNED
1A
PRINTER NUMBER
NOT DEFINED
1B
PRINTER NUMBER
IN USE
Reset or power cycle the print server to enable the new configuration
values.
The configuration information for the NetWare functions is not stored
correctly on the print server. Use the installation software, embedded
web server, or other tools to reconfigure the print server. If this error
persists, there may be a problem with the print server.
The print server has not been configured for NetWare. Use the
installation software, embedded web server, or other tools to configure
the print server for NetWare networks.
The print server was unable to find the NetWare print server (in Remote
Printer mode) or file server (in Queue Server mode). There was no
response to service queries for advertising print servers or file servers
that matched the configured print server or file server name.
Make sure that the print server or file server is running and that the print
server or file server name configured on the print server matches the
actual name used by the print server or file server. Also make sure that
all cables and routers are functioning correctly.
The print server detected that the password for the NetWare print server
object is wrong. Use a NetWare utility (such as PCONSOLE) to erase
the password for the print server object. When the print server logs on
again, it sets a new password.
Note: When multiple file servers are configured, the error is only
displayed on the configuration page if none of the file servers are
connected.
The HP Jetdirect print server detected that the print server object has not
been assigned any queues to service. Assign queues to the print server
object using printer installation or NetWare utilities.
Note: When multiple file servers are configured, the error is only
displayed on the configuration page if none of the file servers was
successfully connected.
A NetWare printer number for this printer has not been configured.
Assign a valid printer number to the print server. Use a NetWare utility
(such as PCONSOLE), the Jetdirect embedded web server, or another
tool to assign a printer number.
The NetWare printer number assigned to the printer is already in use by
another printer. Assign an unused printer number. This may also occur
when a printer is power cycled, in which case the error goes away after
the print server times out and detects the lost connection.