HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 40

trap-dest:
trap-community-name:
IPX/SPX parameters for TFTP
TFTP Parameter
Enables or disables IPX/SPX protocol operation on the print server:
ipx-config:
A user-assigned alphanumeric name assigned to the print server (31 characters maximum).
ipx-unit-name: By default, the name will be NPIxxxxxx, where xxxxxx are the last six digits of the
hardware address (MAC or LAN address).
Specifies the IPX frame type setting, one of the following: AUTO (default), EN_SNAP,
ipx-frametype:
EN_8022, EN_8023, EN_II, TR_8022, TR_SNAP.
Specifies the time interval (1–3600 seconds) that the print server waits between Service
Advertising Protocol (SAP) broadcasts on the network. The default is 60 seconds. 0 disables
ipx-sapinterval:
SAP broadcasts.
[not for 175x] An alphanumeric string, up to 31 characters, that specifies the name of the Novell Directory
Services (NDS) tree for this print server.
ipx-nds-tree:
[not for 175x] An alphanumeric string, up to 256 characters, that specifies the NDS context for the print
server.
ipx-nds-context:
[not for 175x] Specifies the time interval (1–255 seconds) that the print server will wait to check for print
jobs in a print queue. The default is 2 seconds
ipx-job-poll:
Enables or disables printing an IPX banner page using the Printer Job Language (PJL):
ipx-banner:
Enables or disables IPX end-of-job notification using PJL:
ipx-eoj:
Enables or disables IPX toner-low notification using PJL:
ipx-toner-low:
AppleTalk parameters for TFTP
Enters a host's IP address into the print server's SNMP trap destination list. The
command format is:
trap-dest: ip-address [community name] [port number]
ip-address is the host IP adress.
community name is optional (the default community name will be
used), except in two cases:
when specifying the port number. If you do not specify a
community name, the port number will become the community
name.
when a trap-community-name entry precedes any
trap-dest entry. If you do not specify a community name here,
that trap community name will be assigned to this entry.
port number is optional (the default SNMP port number 162 will be
used).
Setting trap-dest: 0 deletes the trap destination list. If the list is empty, the
print server does not send SNMP traps. The list may contain up to five entries. The
default SNMP trap destination list is empty. To receive SNMP traps, the systems listed
on the SNMP trap destination list must have a trap daemon to listen to those traps.
Community name (password) included with SNMP traps that are sent by the print
server to a host computer. Community names must be ASCII characters. The
maximum length is 255 characters.
0 Disables.
1 (default) Eenables.
0 Disables.
1 (default) Enables.
0 Disables.
1 (default) Enables.
0 Disables.
1 (default) Enables.
Description