HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 83

Sets the network link speed (10- or 100-Mbps) and communication
mode (full- or half-duplex) for the print server.
Caution! If you change the link setting, network communications
with the print server and the attached printer may be lost.
Link Settings
Specifies the encoded source facility of a syslog message (for
example, to identify the source of selected messages during
troubleshooting). By default, the print server uses LPR as the
Syslog
source facility code, but local user values of local0 through local7
Facility
can be used to isolate individual or groups of print servers. See the
syslog
Settings
Allows additional ports to be specified for printing to TCP port
Dynamic Raw
9100. Valid ports are 3000 to 9000, which are application
Port Setting
dependent.
Enable or disable the print server's support of the full-function
scanning facility installed on the computers (the client software
Enable MFP
from the MFP's CD) for an HP multifunction (MFP or All-in-One)
and AIO
device. Disabling this causes the print server to disallow all
software
functions other than printing over the network. (Support for basic
support
scanning using the print server's Web Scan facility is separate; see
following
Enable or disable use of the basic scanning facility provided by the
print server's embedded web server Scan page (details).
Availability of this facility is separate from support of the client's
Enable Web
full-function scanning software (see
Scan
The features include displaying and downloading scanned files.
Whether scanning to e-mail is also enabled with this facility is
determined by the setting of the following parameter.
Enable or disable use of the scanning to e-mail facility—sending
the file—provided by the print server's embedded web server Scan
page
Enable
scanning to email is available, in addition to displaying and
Scan-to-email
downloading scanned files. The e-mail facility is accessible for
users only when the mail server is set for the
Server
AUTO
(the default) causes the print server to attempt to
automatically configure its port to match the network's link
speed and communication mode. If it fails, then 100-Mbps,
half-duplex operation is set.
10TXFULL
10-Mbps, full-duplex operation
10TXHALF
10-Mbps, half-duplex operation
100TXFULL
100-Mbps, full-duplex operation
100TXHALF
100-Mbps, half-duplex operation
description. See also other
menu.
parameter.)
(see preceding parameter).When this parameter is enabled,
parameter (see following
syslog parameters in the
preceding parameter).
Email (SMTP)
parameter).
TCP/IP