HP Jetdirect 310x - Print Server For Fast Ethernet User Manual page 129

3A
UND ERR:
UNABLE TO FIND
TREE
3B
NDS CONNECTION
STATE ERROR
3C
NDS ERR:
UNRESOLVED
QUEUE
3D
NDS ERR:
CANNOT READ Q
HOST
3E
NDS PRNT SRVR
PUBLIC KEY ERR
3F
UNABLE TO GET
NDS SRVR ADDR
40
ARP DUPLICATE
IP ADDRESS
41
NOVRAM ERROR
42
INVALID IP
ADDRESS
43
INVALID SUBNET
MASK
44
INVALID
GATEWAY
ADDRESS
45
INVALID SYSLOG
ADDRESS
The NDS tree cannot be located. The message may occur when the file
server is not running or when a network communications problem
exists.
The print server cannot change the NDS connection state. Check
licenses on the spooling server.
The print queue object cannot be located in the specified NDS context.
Cannot locate the file server on the network. The server may not be
running at this time or a communications problem may exist.
Print Server Object Name mismatch. Unable to read the print server's
public key. Verify object names. Verify that the object key assigned to
the print server is a print server object and not a printer or other object.
The NDS server address cannot be located or accessed.
The ARP layer has detected another node on the network using the
same IP address as the print server. Extended error information below
this message shows the hardware address of the other node.
The print server cannot read the contents of its NOVRAM. Cycle power
on the print server by unplugging is power cable and plugging it back
in. If the problem persists, perform a
(while holding down the test
plug the power module back into the print server and continue to hold
down the test button for about five seconds. Any user-configured
settings will be erased.) If the problem still persists,
support for help.
The IP address specified for the print server (through BOOTP) is an
invalid IP address for specifying a single node. Check your Bootptab
file for proper entries.
The IP subnet mask specified for the print server (through BOOTP) is
an invalid subnet mask. Check your Bootptab file for proper entries.
The default gateway IP address specified for the print server (through
BOOTP) is an invalid IP address for specifying a single node. Check
your Bootptab file for proper entries.
The syslog server IP address specified for the print server (through
BOOTP) is an invalid IP address for specifying a single node. Check
your Bootptab file for proper entries.
cold reset on the print server
button on the back of the print server,
call HP technical