Mounting The Front Bezel - HP D5970A - NetServer - LCII Installation Manual

Chapter 8
9. If the Cable Management Arm installation appears to be successful,
continue with the next procedure, "Mounting the Front Bezel.

Mounting the Front Bezel

The front bezel is attached to the HP NetServer with a hinge and a latch. The
hinge and latch must be attached to the front of the HP NetServer before mounting
the bezel.
1. Place the hinge into the slots on the front of the HP NetServer at the left
front edge, as shown in Figure 8-13.
The two hooks on the rear of the hinge must fit into the two matching holes
on the front of the HP NetServer. The hooks attach the hinge to the HP
NetServer, but not securely.
1. Place hinge against
front of NetServer,
inserting hooks into
matching holes as shown.
Figure 8-13. Attaching the Bezel Hinge to the HP NetServer
Rack Mounting the HP NetServer
2. Swing to left
to bring it against
front of NetServer
103