Opening And Closing The Hp Netserver; Removing And Replacing The Front Bezel - HP D5970A - NetServer - LCII Installation Manual

3 Opening and Closing the
HP NetServer

Removing and Replacing the Front Bezel

The front bezel is attached to the front of the HP NetServer using a hinge and
latch. The bezel is mounted onto the hinge with three clips. You can swing the
bezel open on its hinge, or remove the bezel entirely.
NOTE
HP NetServers installed in non-HP racks use a different front
bezel for mounting. For more information, refer to the separate
rack-mounting guide for third-party racks. It is packed in the
accessories tray in the HP NetServer's shipping box.
1. To swing open the bezel, grasp it by the handle on its right edge and pull it
open to the left.
This exposes the mass storage devices and memory board bays (covered).
2. To remove the front bezel, pull it straight forward off the chassis.
3. To replace the bezel, press it back onto the chassis, allowing it to snap into
place. See Figure 3-1.
Figure 3-1. Removing and Replacing the Front Bezel
27