HP D5970A - NetServer - LCII Installation Manual page 67

Chapter 5
4. Lift the DIMM completely away from the slot. See Figure 5-8.
5. Place the DIMM in its anti-static container.
6. Repeat Steps 2 through 5 to remove any additional DIMMs on the board.
NOTE
Ensure all retaining clips on the memory board are closed
before re-inserting it into the HP NetServer. This includes clips
on empty slots as well as those on slots containing DIMMs.
7. If necessary, remove the other memory board to remove the identical
DIMMs on it as well.
8. If all DIMMs have been removed, follow Steps 22-30 in "Installing
Additional Memory" earlier in this chapter to install the memory board(s)
and restore power to the HP NetServer.
Figure 5-8. Removing a DIMM Module
Installing Additional Memory
59