HP D5970A - NetServer - LCII Installation Manual page 76

Chapter 6
Figure 6-4. Removing the PCI Slot Cover
NOTE To prevent intermittent problems, ensure each unused PCI slot
has a PCI slot cover in place. If a PCI board is removed and not
re-installed, you must ensure the unused slot has a PCI slot
cover installed.
9. Open the PCI board guide latch before installing the new PCI board. See
Figure 6-5.
CAUTION
Do not bend the PCI board to install it into the slot.
If the PCI board is full-length, the PCI board guide latch at the
rear of the PCI slot is used to hold the board in place. The
latch at the top of PCI board guide prevents the board from
moving during HP NetServer transportation and handling
when performing PCI Hot Plug operations.
68
Installing Additional Boards
A. Push here
from outside
PCI
to move in.
Slot
Cover
B. Lift Up
and Out
of Slot