HP D5970A - NetServer - LCII Installation Manual page 53

Chapter 7
11. Position the PCI card, component side up, and slide it into the slo t.
CAUTION
Do not bend the PCI card to fit it into the slot. Check to make
sure you removed any handles or board extenders as shown in
Figure 7-1.
12. Use the T15 driver to screw the PCI card rear panel to the I/O panel at the
rear of the LPr chassis. Refer to Figure 7-5.
13. Position the PCI retaining bracket and screw it down with the T15 driver.
14. Align the PCI access cover and snap it into place.
NOTE The PCI access cover hinges at the bottom and swings in at
the top. The tabs at the bottom should capture the AC power
line on the enclosure floor and hold it against the enclosure
side.
Once the PCI card is installed, simply reboot the system. The drivers for the new
card are either part of your existing system software, or you will load drivers
from a floppy diskette that accompanies your upgrade card.
Figure 7-5. Inserting a PCI Card
Installing Additional Boards
45