HP D5970A - NetServer - LCII Installation Manual page 58

Chapter 7
5. If you wish to continue to use the embedded SCSI controller to connect to
external SCSI devices (a tape drive for example), you will have to order
an accessory kit with a special SCSI cable that provides termination at the
end opposite the SCSI terminator card.
Figure 7-10 shows this cable after installation. Remove the adhesive strip
from the terminator block and stick it on the floor of the LPr chassis in the
area outlined by scribe lines. The connector in the middle of the cable
goes on the embedded SCSI connector shown in Figure 7-9. For more
details see the instructions in the accessory kit.
Figure 7-10. Cable for Connecting Embedded SCSI Controller to
50
External SCSI Devices
Installing Additional Boards