Hp Netserver Lpr Rack Mount Parts List - HP D5970A - NetServer - LCII Installation Manual

Chapter 9
Air Flow. As you mount equipment in the rack, make sure that you allow
enough air flow for safe operation of the equipment.
Mechanical Loading. Uneven mechanical loading within the rack can
cause hazardous conditions. Plan the placement of equipment in the rack
to make sure that this problem does not occur. Mount the heaviest
components in the bottom of the rack.
Circuit Overloading. Make sure that the total configuration of equipment
in the rack does not overload the supply circuit. To this end, check the
nameplate ratings on all equipment. Consider the effect of circuit
overloading on over-current protection and supply wiring.
Reliable Earthing (Grounding). Maintain reliable earthing (grounding)
of rack-mounted equipment. Give particular attention to supply
connections that are not direct connections to the branch circuit (the use
of power strips, for example).

HP NetServer LPr Rack Mount Parts List

The rack-mount kit that accompanies the HP NetServer LPr should contain the
following parts:
Table 9-1. Parts for Rack Mount Kit
Quantity
2 Rails 2, pieces each (will mount on either
side)
2 Brackets (used at rear of rails to dampen
chassis vibration)
12 Rack nuts (sheet metal nuts)
12 Torx screws
Mounting the Server in the Rack
Description
63