Remove Bezel, Control Panel, & Covers - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 3
Remove Bezel, Control Panel, & Covers
9. Unscrew front bezel hinge.
Figure 3-2. Remove Bezel, Bezel Hinge, and Control Panel
8. Remove the front bezel from the NetServer. Pull it straight out off the
chassis. (See Figure 3-2.)
Place the front bezel on the table of items that will not be reused in the
NetServer LXr 8500.
9. Detach the front bezel hinge from the chassis. Insert the Torx
through the hinge to remove all three screws. (See Figure 3-2.)
Place the front bezel hinge on the table if items that will not be reused. You
received a new front bezel hinge in the upgrade kit.
10. Remove the plastic control panel by depressing the two latches located on
either end of the control panel. (See Figure 3-2.)
This item will be reused in the NetServer LXr 8500.
Disassembling the LXr 8000
10. Remove control panel.
8. Remove front bezel.
®
driver
21