Run The Basic System Test - HP D7171A - NetServer - LPr Upgrade Manual

Chapter 8
NOTE HP DiagTools Diskette #1 contains a
notes. View the
information about DiagTools.

Run the Basic System Test

Running the Basic System Test has two parts:
l
In Configuration Detection, DiagTools identifies all installed components.
l
The Basic System Test gives pass/fail results on each detected component.
To run the Basic System Test:
1. Insert HP DiagTools Diskette #1 and restart the NetServer if you haven't
done so already.
The Welcome screen appears.
2. Press F2 and follow the instructions on the screen to begin Configuration
Detection.
HP DiagTools scans the NetServer and identifies all installed components,
such as processors, memory, and SCSI devices.
3. Scroll through the list of detected components, and make note of any items
that were not detected. HP DiagTools cannot test components it has not
detected.
NOTE
HP DiagTools does not list the CD-ROM drive on the
Configuration Detection screen.
HP DiagTools is not designed to handle hot swapping. If you
hot swap any components while HP DiagTools is running, you
must restart DiagTools and perform a new Configuration
Detection.
4. Press F2 and follow the instructions on the screen to start the Basic System
Test.
The screen displays the tests and results as they are performed. When the
test is complete, you see a summary of the results.
If all tests passed, you can either exit DiagTools or view or print your
results by following the instructions in the section "Create a Support
Ticket."
Reinstalling Your NOS
readme
readme file to look for the most recent
file of release
79