(3) When setting is completed, the All settings have been cancelled
message appears.
Click [OK].
The MN Converter switches to maintenance mode, and
the message below appears.Click [OK].
NOTE:
After cancellation, check the start/stop condition of the unit for confirmation
(4) Click [Close] to close the Error notification mode setting/cancellation screen.
NOTE:
If you selected "Connection with host SC", you must delete the address of the MN Converter from
the connection data for the corresponding unit on the host SC.
3.12.8 Option settings
Use the procedure below to specify the settings for remote error notification mode.
(1) Click [Option] in the menu bar and
select [Error notification mode] ->
[Option setting] in the sub-menu.
(2) The Option setting screen appears.
(3) Change the settings as desired and click [Transmission].
69