Table of Contents
Advertisement
Step 2) Setting up the Maintenance Tools
Set up the application of this Maintenance Tools . Please read the guide shown on the screen carefully
to proceed the setting up.
(1) Starting the setup program
1) Start MntToolE.EXE.
Execute "MntToolE.EXE" located in
SetUp ¥2_MNTTOOL folder of CD-ROM.
Double clicking on "MntToolE.EXE" with the explorer
displays "Welcome" screen. Please confirm the caution
shown on the screen before setting up.
2) Confirm the display contents, and select [Next] button.
If no problem was found on the content, click [Next] button.
* To stop setting up, click on [Cancel] button.
(2) Confirming the Installation folder
1) Confirm the installation folder and select [Next] button.
Confirm the folder on which this program should be installed.
To change the installation folder (C drive only),
Use [Browse] button. After confirming the installation
folder, click on [Next] button.
* Clicking on [Cancel] button stops installation procedure.
(3) Confirming the installation start
1) Confirm the starting and select [Next] button.
Clicking on [Next] button starts installation.
* Clicking on [Cancel] button stops installation.
(4) During installation, a command prompt like the one shown
on the right appears as the process is performed.
Setup may take up to three minutes to complete.
Caution:
During Database setting, the process may be observed as stopped for a while. However, it is still under
operation internally. Wait for some time until "Press any key to continue - - - -" appears without doing anything.
*Do not stop the set up procedure by pressing
at the upper right of the screen.
8
Hide quick links:
Advertisement
Table of Contents
