Craftsman 113.298090 Owner's Manual page 16

assembly
4. If blade is SQUARE to table; check pointer.
A. IfPointer DOES NOTpoint to"0" markon the Bevel
Scale, bend pointer to read "0".
5. If blade is NOT SQUARE to table, the 900 Limit Stop
must be adjusted.
]CAUTION: Cover blade with p,ece of card- i
board to protect your hand.
A. Using a small size screwdriver, reach underneath
saw and loosen BOTH setscrews in 90 ° Stop
Collar.
NOTE: If you can't reach the setscrews turn the
Tilt Handwheel slightly.
B. Rotate the Stop Collar moving it away from pivot
nut.
C. Tilt blade RIGHT or LEFT, checking with your
square until blade is square to table.
D. Rotate Stop Collar toward Pivot Nut until it
TOUCH ES the Pivot Nut. Tighten the setscrews.
E. Check Pointer, if it DOES NOT point to the "0"
mark onthe bevel scale, bend Pointer to read "0".
POINTER
ADJUSTING SCREW
r
o / Q
_/CP_FTgN_N
"O" POSITION\ _F_ / k .,
s il _.l'I/l"111'*_J_',lll'_llI"_\
,o 2# 2s 30 3_ 40 _
10"
Direct Drive .......... _ HP
G[ _..NGER I
............ -F
BLADE COVERED
WITH P!ECE OF
CARDBOARD
/
1
/
/
\,h
SETSCREWS (2)
PIVOT NUT
90° STOP COLLAR
6. Tilt blade to LEFT as far as itwill go. It will stop when
the Pivot Nut is against the 45 ° Stop Collar.
7. Place an ACCURATE square against blade. Make
sure square is nottouching the TIP of one of the saw
teeth.
16