Craftsman 113.298090 Owner's Manual page 42

basic saw operations
When WIDTH OF RIP is 1/2 inch to 2 inches, the Push
Stick CANNOT be used because the Guard will inter-
fere. USE the Auxiliary Fence/Work Support and Push
Block.
Attach Auxiliary Fence/Work Support to Rip Fence with
two "C" clamps.
Feed the workpiece by hand along the Auxiliary Fence
until the end is approximately 1 inch past the front edge
of the table. Continue to feed using the Push Block.
Hold the workpiece in position and install the Push Block
by sliding it on top of the Auxiliary Fence/Work Support
(this may raise Guard).
WARNING: To avoid injury from blade contact, I
never thru-saw cuts narrower than 1/2 inch wide. '1
Narrow strips thicker than the Auxiliary Fence/Work
Support may enter the Guard and strike the Baffle.
CAREFULLY raise Guard only enough to clear the
workpiece. Use Push Block to complete cut.
BAFFLE
42