Craftsman 113.298090 Owner's Manual page 20

assembly
2_ insed a 5/16-18 x 1-I/2 inch long hex head screw,
external !ockwasher and fiat washer through the
SECOND slot _nthe front fence bar
3. Piace t/2 inch _ong Spacer over screw threads and
thread hex head screw into first hole On the right side
o_the cast iron table skirt until finger tigh_ Guide Bar
should be in a vertical position.
/
/
4 Mount Switch to Guide Bar with (2.) two 5/16-18 x
314 hex head screws, Iockwashers, and nuts. Se-
curely tighten both bolts.
5_ Insert 1-1/2 inch long screw tl_rough external
tockwasher, flat washer and through the first slot in
the Guide Bar. Place 1/2 inch long Spacer over
screw threads. Swing Guide 8at to horizontal
position and thread the hex head screw into the
hole of the table skirt Finger tighten.
6. Insert 1-!/2 inch long screw through flat washer and
the FOURTH slot in the Guide Bar. Place 1/2 inch
long spacer over screw threads, Insert screw into
slot in bracket and attach a lockwasher and nut.
Finger tighten.
FLAT
1-1i2" HEX
HD. SCREW
LOCKWASHER
5/164 8 X 3/4"
flEX HD.
!
/
SPACER
LOCKWASHER
/
1-1i2" HEX
HD. SCREW
LO4b"_WASHER
HUT
l
BRACKET
SPACER
FLAT
WASHER
2O