Table of Contents
Advertisement
general information
BOTH MODELS
1. This manual is for the following Models, 113.226880
or 113.298090.
All sections are labeled with the correct model num-
ber. Follow ONLY instructionsthat are meant foryour
model saw.
2. If you are missing any part(s) while putting your saw
together, do not continue assembly.
Contact your
Sears Service Center or Retail Store and get the
missing part(s) before continuing assembly or trying
to use the saw.
Complete parts lists are located at the end of this
manual. Use these liststo identify the part number of
any missing part.
3. Sometimes small parts get lost in packaging materi-
als. Do not throw away any packaging until your saw
is put together.
If you are missing a part, check the
packaging before contacting Sears.
MODEL
DESCRIPTUON
Model 113. 226880:10-inch
direct drive table saw with
a 20 x 20 inch CAST IRON table and two 10 x 20-inch
CAST IRON extensions.
Model 113. 298090: 10-inch direct drive table saw with
a 20 x 27-inch die cast ALUMINUM
table and two 10 x
27-inch STAMPED STEEL extensions,
unpacking and checking contents
TOOLS NEEDED
Pliers
Combination Square
MediumScrewdriver
SmallScrewdriver
#2 Phillips Screwdriver
_
Wrench, Hex "L" 3/16
"K_
Wrench, Hex'L"
1/8
Wrenches
3/8 in.
7/16 in.
1/2 in.
9/16 in.
COMBINATION
SQUARE
MUST
BE TRUE.
DRAW
LIGHT
LINE
ON
BOARD ALONG
THIS EDGE.
'3",
i
•
I
L_
STRAIGHT
EDGE
OF BOARD
3/4"
THICK.
THIS
EDGE
MUST
BE PERFECTLY
STRAIGHT,
I
SHOULD
BE NO
GAP
OR
OVERLAP
HERE
WHEN
SQUARE
IS FLIPPED
OVER
IN DOTTED
POSITION.
Model 113.226880 or 113.298090 is shipped complete
in one carton and includes two table extensions, steel
legs and motor.
Separate all parts from packing materials and check
each one with the illustration and the list of Loose Parts
to make certain all items are accounted
for, before
discarding any packing material.
WARNING:
If any parts are missing, do not at-
tempt to assemble
the table saw, plug in the
power cord or turn the switch on until the missing
parts are obtained and are installed correctly.
Remove the protective oil that is applied to the table top
and edges of the table. Use any ordinary household type
grease and spot remover.
WARNING: To avoid fire or health hazard, never I
use gasoline, naptha
or similar highly volatile
I
solvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth.
WARNING:
For your own safety, never connect
plug to power source outlet until all assembly
steps are complete, and you have read and under-
stand the safety and operation instructions.
8
Hide quick links:
Advertisement
Table of Contents
