Attaching And Assembling Table Extensions - Craftsman 113.298090 Owner's Manual

assembly
MODEL 113.298090 ONLY
ATTACHING AND ASSEMBLING
TABLE EXTENSIONS
HEX HD. SCREW
1. From among the loose parts, find the following hard- 5/16-18 X 1-1/4
ware: (Quantity indicated is for 2 extensions.)
*8 Hex Hd. Screws, 5/16-18 x 1-1/4
*8 Flat Washers, 21/64 x 5/8 x 1/16
*8 Lockwashers, External 5/16
*8 Hex Jam Nut. 5/16-18
"16 Truss Head Screws, 1/4-20 x 1
"16 Hex Nut, 1/4-20
"16 Lockwashers, External 1/4
*4 Flat Washers, 17/64 x 3/4 x 1/16
4 Corner Support Brackets
4 Corner Stiffener Brackets
2 Brackets
HEX NUT
5/16-18
FLAT WASHER
17/64 IN. I.D.
Items marked with an asterisk (*) are shown actual size.
FLAT WAS H ER
21/64 IN. I.D.
TRUSS HD. SCREW HEX NUT
1/4-20 X 1 IN. 1/4-20
CORNER CORNER
STIFFENER SUPPORT
BRACKET BRACKET
EXTERNAL
LOCKWASHER
5/16 IN.
EXTERNAL
LOCKWASHER
1/4 IN.
BRACKET
2. Position saw upside down on floor.
NOTE: To protect the finished surfaces of the saw
and extensions, lay a piece of heavy paper or card-
board on the floor.
3 Install Corner Support Brackets, Corner Stiffener
Brackets, 1/4-20 x 1 inch truss head screws, 17/64
inch flat washers, 1/4 inch external lockwashers, and
1/4-20 hex nuts as shown. Hand tighten only.
CORNER
STIFFENER 17164 DIA.
BRACKET FLAT WASHER
1/4-20 tJ_J_
_-H=.nRT _..-_"_._}"_,,_'-_
_.1/4
IN. EXTERNAL
BR'A'CKi_Tf '\\\ __LOCKWASHER
TRUSS HEAO
\ \_ __.]._
SCREW ,-_-_ _ _
THIS EDGE TOWARD TABLE
4. Insert four (4) 5116-18 x 1-1/4 inch hex head screws
into holes on inside edge of one extension.
5. Install 11/32 i.D. flat washer, 5/16externam Iockwasher,
and 5/16-18 hex nut on the end of each screw. Just
start nut on end of screw.
6. Slide the extension with hardware into four slots in
side of table. LINE UP FRONT EDGE OF EXTEN-
SION WITH FRONT EDGE OF TABLE and tighten all
screws and nuts.
7. Repeat for other extension.
LOCKWASHER
WASHER
5/16-18 X 1-1/4 SCREW
22