Table of Contents
Advertisement
motor
LUBRiCATiON
AND MAINTENANCE
1. The beadrK:js,in both end shields of the motor, have
been lubricated at the factory with correct lubricant.
No other part of the motor requires lubrication.
2. if disassembly of the motor is necessary, itshould be
returned to your nearest Sears retail or main-order
store in order to prevent voiding the guarantee.
NOTE: The speed of this motor cannot be regulated
or changed.
3. Every effort should be made to prevent foreign mate-
riat trom entering the rr_tor.
When operated under
conditions likely to permit accumulations
of dust, dirt,
or waste within the motor, a visual inspection should
be made at frequent intervals. Accumulations
of dry
dust can usually be blown out successfully.
NOTE:
Motors used on wood-working
tools are
particularly susceptible to the accumulation of saw-
dust and wood chips and should be blown out or
"vacuumed" frequently to prevent interference with
normal motor ventilation.
maintenance
WARNING: To avoid injury from accidental start,
turn switch "OFF" and remove plug from power
source outlet
before maintaining
or lubricating
your saw.
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate
inside the saw cabinet and the motor.
Frequently clean your cutting tools with Craftsman Gum
and Pitch Remover.
A coat of automobile-type
wax applied to the table will
help to keep the surface clean and allow workpieces to
slide more freely.
It the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Make sure the teeth of the Anti-Kickback Pawls are
always sharp. To sharpen:
1. Remove Blade Guard.
2. Rotate Pawl toward rear of Spreader so that teeth are
above top of Spreader.
3. Hold Spreader with left hand and place Pawl over
corner of workbench.
4. Using a small round file (smooth cut) sharpen the
teeth.
46
Hide quick links:
Advertisement
Table of Contents
