Motorola MOSCAD 68P02958C00-B User Manual page 381

transmission to it results in an ICMP:Dest Unreach error message, or when the 'check alive' test
fails. Use of this parameter makes MLDC over IP more reliable when transmitting to failed sites.
15. If 'Check failed sites' is YES, this specifies the number of retries of the 'check alive' test to the
failed site, before the message is routed to an alternative path (if such exists) and asserting that it is
still failed.
16. If 'Check failed sites' is YES, this specifies the timeout in seconds between retries of the 'check
alive' test.
17. If 'Check failed sites' is YES, this specifies the timeout in seconds in which no message was
received from a site before declaring it as unknown. Any new transmission to the site will first cause
a 'check alive' test as explained above. This parameter is extends the 'check alive' test to sites
which are not failed, but have been idle for some time. If this parameter is set to 0, no 'check alive'
test will be performed for idle sites.
## 2201 LEVEL = 1
Iplink socket status
---------------------
Socket number
Socket state
Socket timeout
Socket open latest result : %%
Socket send latest result : %%
Socket recv latest result : %%
Status of the socket on the link. For system software developers only.
## 2202 LEVEL = 2
Iplink status
--------------------------
Queue size
Is transmission thread waits for new buffer
If transmission thread waits for socket to be opened
Is transmission thread waits for socket to transmit data
Is reception thread waits for socket to received new data : %%5
Last transmitted site ID
Last transmitted IP address
Last received site ID
Last received IP address
1. Number of frames awaiting transmission.
2. Not relevant.
3. Not relevant.
4. Not relevant.
5. Not relevant.
6. Last Site ID to which the RTU transmitted.
7. Last IP address to which the RTU transmitted.
: %%
: %%
: %%
C-89
Software Diagnostics Output
: %%1
: %%2
: %%3
: %%4
: %%6
: %%7
: %%8
: %%9