Motorola MOSCAD 68P02958C00-B User Manual page 400

## 2525 LEVEL = 105
LAPi related statistics in iDEN modem:
--------------------------------------
Number of PRAP message expirations
Number of Inbound I PDUs sent (not including retries)
Number of Inbound All Block Retry I PDUs sent
Number of Inbound Retry I PDUs sent
Number of Outbound I PDUs received (not including retries)
Number of Outbound Retry I PDUs received
Number of PDUs lost when the LLC receives a Local Release
Number of PDUs lost due to an error or connection loss
Number of Inbound user bytes requested to be transmitted
Number of Outbound user bytes received
Number of half duplex collisions detected by the LAPi LLC
Number of SABME received because of N(R) or timeout in peer : %%12
Number of unexpected UAs received
Number of unexpected DMs received
Number of retransmissions exhausted while connect/disconnect: %%15
Number of retransmissions exhausted while transmitting I PDU: %%16
Number of N(R)s received out of valid range
Number of N(S)s received out of valid range
Number of Retry I PDUs received without Original I PDU
Number of reliable datagrams from client too big to send
Number of unreliable datagrams from client too big to send
Number of PDUs received in a state when they were invalid
The number of invalid PDUs received from FNE
The number of multiple block I PDUs with an LLC FCS error
The parameters are obtained via RALP from modem. Only the important parameters are described
below:
2. Number of messages sent over the air towards the MDG/iDEN system. Not including the number of
retries in #3 and 4.
3,4. Number of retries for messages sent over the air towards the MDG.
5. Number of messages received from the MDG. Not including the number of retries in #6.
6. Number of retries received from the MDG.
9. Number of bytes transmitted over the air towards the MDG.
10. Number of bytes received over the air from the MDG.
All other parameters denote communication problems over the air. Contact system
administrator/technical support if not 0.
Note: After executing diagnostics, these parameters are reset in the modem.
Refer to iDEN documentation such as iDEN Protocol Manual 68P81129E10-B for an explanation of the
LAPi protocol and meaning of parameters.
C-108
Software Diagnostics Output
: %% 1
: %% 2
: %% 3
: %% 4
: %% 5
: %% 6
: %% 7
: %% 8
: %% 9
: %%10
: %%11
: %%13
: %%14
: %%17
: %%18
: %%19
: %%20
: %%21
: %%22
: %%23
: %%24