Compliance Statements - Fujitsu PRIMERGY BX600 User Interface Description

Compliance Statements

1.2 Compliance Statements
FCC Class A Compliance
This equipment has been tested and found to comply with the limits for a "Class A" digital
device, pursuant to Part 15 of the FCC rules and meets all requirements of the Canadian
Interference-Causing Equipment Regulations. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in strict accordance
with the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
 R eorient or relocate the receiving antenna.
 I ncrease the separation between equipment and the receiver.
 C onnect the equipment into an outlet on a circuit different from that to which
connected.
 C onsult the dealer or an experienced
Fujitsu Siemens Computers is not responsible for any radio or television interference caused
by unauthorized modifications of this equipment or the substitution or attachment of connecting
cables and equipment other than those specified by Fujitsu Siemens Computers. The
correction of interferences caused by such unauthorized modification, substitution or
attachment will be the responsibility of the user.
You may use unshielded twisted-pair (UTP) cables for RJ-45 connections – Category 3 or
greater for 10 Mbps connections, Category 5 for 100 Mbps connections, and Category 5 or 5e
for 1000 Mbps connections.
Wear an anti-static wrist strap or take other suitable measures to prevent
!
electrostatic discharge when handling this equipment.
Industry Canada - Class A
This digital apparatus does not exceed the Class A limits for radio noise emissions from digital
apparatus as set out in the interference-causing equipment standard entitled "Digital
Apparatus," ICES-003 of the Department of Communications.
Cet appareil numérique respecte les limites de bruits radioélectriques appli- cables aux
appareils numériques de Classe A prescrites dans la norme sur le matériel brouilleur:
"Appareils Numériques," NMB-003 édictée par le ministère des Communications.
9
radio/TV technician for help.
Introduction
the receiver is
Intelligent Blade Panel Module