Starting An Application Program; Using Drive Designators - Epson Apex 20020, 20040 User Manual

4. Next the screen displays the time prompt, like this:
Current time is
Enter new time:
You may enter the correct time in the format shown (such
as : 30 : 00), or you may accept the time shown by
04
pressing
MS-DOS command prompt:
A>

Starting an Application Program

Once you have loaded MS-DOS, you can start using your
application program. If you have already copied the application
program to the hard disk, log onto drive C (and the appropriate
directory, if necessary). Then just enter the necessary command
to start the application program, as described in the program's
manual. From this point on, until you return to the MS-DOS
command prompt, refer to the application program manual for
any instructions on using the program.

Using Drive Designators

MS-DOS uses letters to identify the disk drives in your
computer. If you have one diskette drive, it is known as drive
A. If you have two diskette drives, the top one is called drive A
and the bottom drive is B.
MS-DOS identifies the hard disk as drive C, even if you have
only one diskette drive.
MS-DOS is now loaded and displays the
Enter.
Using MS-DOS With Your Computer
09 : 32 : 21
4-3