Epson PowerLite 6100i User Manual page 112

warning
When installing or
adjusting the ceiling
mount, do not use
adhesives to prevent the
screws from loosening and
do not use any type of oil or
lubricant. These may cause
the projector casing to
crack and the projector
may fall, causing serious
injury and serious damage
to the projector.
Appendix A: Projector Installation
112
To project from overhead, you'll need the optional ceiling mounting
hardware; see page 12 for ordering information. You'll also need to
select or
Front/Ceiling
menu to flip the image upside-down. To project from the rear, select
(see page 59).
Rear
If you're mounting the projector on the ceiling and you place it above
screen level, you'll have to tilt it down to position the image on-screen.
This causes the image to lose its square shape. You can then correct
the distortion by using the
menu system (see page 56) or by using the
projector's control panel.
If you place the projector so that the lens is level with the bottom of
the screen, the image will be square and you won't have to adjust it. If
you place the lens lower than the bottom of the screen, you may have
to tilt the projector upward if you want to fill the whole screen with
the image.
If you want to be able to control the projector's settings from a remote
computer, see Chapter 5.
in the projector's Extended
Rear/Ceiling
function in the projector's
Keystone
or buttons on the