Epson PowerLite 6100i User Manual page 29

3. Press the orange P
press the P
Power
(If this is your first time using the remote control, make sure the
batteries are installed; see page 43.)
Power button
The PPower light flashes green as the projector warms up, and
an image begins to appear. When the PPower light stops flashing
and remains green (in about 20 seconds) the projector is ready
for use.
4. If you've connected a Windows-based computer to the projector,
you may see a New Hardware Wizard saying your computer has
found a plug-and-play monitor; if so, click
button on top of the projector—or
Power
button on the remote control.
.
Cancel
note
If the Direct Power On
feature has been enabled,
you don't need to press the
button to turn
P Power
the projector on. Just plug
the projector into an
electrical outlet. When the
P Power light stops flashing
and stays on, the projector is
ready to use.
warning
Never look into the lens
when the lamp is on. This
can damage your eyes, and is
especially dangerous for
children.
Projecting
29