Epson PowerLite 6100i User Manual page 55

2. Use the pointer button to highlight menu items, then press
the button to select from any of the following options:
Enter
(computer images)
■
Auto Setup
Leave this setting
image when you switch to a computer source. Turn it
you want to save adjustments you have made to the video
settings below.
■ (computer images)
Tracking
Removes unwanted vertical lines from a computer image by
matching the projector's internal clock to various computer
signals. See page 106 for more information about adjusting
the tracking setting.
■ (computer images)
Sync.
Corrects fuzziness or screen flicker by synchronizing the
projector with the tracking signal sent from the computer.
See page 106 for more information about adjusting the sync.
setting.
■ Position
Use the pointer button to move the image on the screen
left, right, up, or down.
■ Computer1 Input
Selects the signal from equipment connected to the
port. If your image colors look wrong, try
Computer1
changing this setting from
RGB video sources, or to
video sources.
■
Computer2 Input
Selects the signal from equipment connected to the
port. If your image colors look wrong, try
Computer2
changing this setting from
RGB video sources, or to
video sources.
■
Video Signal
Leave this setting at
system (select
to automatically optimize the computer
On
to
Auto RGB
Component Video
to
Auto RGB
Component Video
(composite and S-Video)
unless you are using a 60-Hz PAL
Auto
).
PAL60
if
Off
for computer or
for component
for computer or
for component
Configuring the Projector
note
You can also use the remote
control's button to
Auto
automatically reset the
projector's tracking, sync,
and position settings.
55