Using Emp Monitor; Opening And Closing Emp Monitor - Epson PowerLite 6100i User Manual

note
If you're a network
administrator, you can use
the option to enter a
SNMP
trap IP address. This lets you
receive trap alerts for the
projectors you're monitoring.
If you have HP OpenView,
a plug-in will be available
to allow you to manage your
projectors in HP OpenView.
Check with your dealer or
Epson for availability (see
page 109).
Managing the Projector from a Remote Computer
76
4. If your network assigns addresses automatically, turn on the
setting.
DHCP
5. If your network does not assign addresses automatically, turn off
and enter the projector's
DHCP
Gateway Address
To enter numbers, use the
control to highlight the number you want to input, then press the
button. When you're finished changing an address in the
Enter
network menu, highlight
6. When you're done making all necessary changes, press
exit the menu system.

Using EMP Monitor

EMP Monitor lets you manage all your projectors using a remote
computer. This lets you easily turn the projectors on or off (together
or individually), switch image sources, and check on their status.
Before using EMP Monitor, make sure you've installed the software as
described on page 74. The computer you're using to monitor the
projector should already be connected to your network.

Opening and Closing EMP Monitor

To start EMP Monitor, click
EPSON Projector > EMP Monitor
If you've added the program to the Startup programs folder (see
page 84), then it may already be open. If so, click the icon in the
system tray on the lower-right corner of your screen to display the
EMP Monitor window:
To close EMP Monitor, select
the program icon shown above, then select
IP Address
, and , as needed.
MAC Address
pointer button on the remote
, then press the
Finish
Start > Programs
.
Click here to start EMP Monitor
from the File menu or right-click
Exit
Exit
, ,
Subnet Mask
button.
Enter
to
Menu
or
All Programs >
.