Hitachi XP P9500 User Manual page 158

Perform this step if your host OS uses LUKS. If HDLM manages a SCSI
device that has been configured to use LUKS, the LUKS settings must be
migrated from the SCSI device to an HDLM device.
For details on setting up LUKS, see
15 If md devices are used, execute the following command to activate them:
.
# mdadm -A -scan
mdadm: /dev/md0 has been started with 2 drives.
16 If md devices are used, execute the following command to make sure that
.
they have been activated.
In the following example, RAID1 (mirroring) is used:
# cat /proc/mdstat
Personalities : [raid1]
md0 : active raid1 sddlmaa1[0] sddlmab1[1]
unused devices: <none>
Make sure that md0 : active is displayed and that the HDLM devices are
displayed.
17 Specify the settings required for using the volume management software.
.
If you performed the operations described in
Group on page 3-85
installation of HDLM on page
the volume group:
If you did not perform step 12:
If you performed step 12:
If you do not use the volume management software, go to step 22.
For details on other settings for the volume management software, see
Settings for LVM2 on page
18 Activate the volume group.
.
In the following example, the logical volume on the HDLM device belongs
to the vg01 volume group:
# vgchange -ay vg01
vgchange -- volume group "vg01" successfully activated
19 Mount the logical volume on the HDLM device.
.
In the following example, the logical volume is /dev/vg01/lvol1 and the
command mounts the volume on /mnt/lvol1:
# mount /dev/vg01/lvol1 /mnt/lvol1
20 Specify the settings required for using virtual environments.
.
3-90
5238528 blocks [2/2] [UU]
in Preparations for an Upgrade Installation or Re-
Go to step 18.
Go to step 19.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Settings for LUKS on page
Deactivating the Volume
3-84, perform the following steps to activate
3-166.
3-152.