Hitachi XP P9500 User Manual page 446

allocation fails, the KAPL05708-E message is output to syslog and to the
HDLM manager log file.
retrycount
-inqt
Specify, in seconds, the timeout value of the SCSI INQUIRY command. In
HDLM, the default timeout value is 30 seconds. Note that the timeout
value specified by using the -inqt parameter only applies to the SCSI
INQUIRY command executed from HDLM. This value has no effect on the
SCSI INQUIRY command executed from another application.
InquiryTimeout
-inqr
Specify the number of retries of the SCSI INQUIRY command. In HDLM,
the default number of retries is 1. Note that the number of retries
specified by using the -inqr parameter only applies to the SCSI INQUIRY
command executed from HDLM. This value has no effect on the SCSI
INQUIRY command executed from another application.
InquiryRetry
7-36
Specify a numeric value from -1 to 2,147,483,646.
-1 : The system retries until memory is allocated. This is the initial
value of the system.
0 : The system does not retry.
1 to 2,147,483,646: The system retries the specified number of
times.
If the following values are specified, the message KAPL12559-E is
displayed and then the processing terminates:
• Non-numeric value
• Value less than -1
• Value more than 2,147,483,646
Specify a numeric value of -1 or in the range from 1 to 3,600.
-1: This sets the timeout value to 30 seconds, which is HDLM's default
value.
1 to 3,600: Timeout value (in seconds)
If the following values are specified, the message KAPL12553-W is
displayed and then the processing ends:
• 0
• Value of -1 or less
• Value more than 3,600
• Non-numeric value.
Specify a numeric value in the range from -1 to 2,147,483,646.
-1: This sets the number of retries to 1, which is HDLM's default
value.
0: The system does not retry.
Utility Reference
Hitachi Dynamic Link Manager User Guide (for Linux(R))