Installing Products That Use The Weak-Modules Script - Hitachi XP P9500 User Manual

Overview
If you use an HDLM device as a boot disk in Red Hat Enterprise Linux 5 and
attempt to install or uninstall a product that uses the weak-modules script,
the following message might be output, and installation or uninstallation of
that product might fail:
grubby fatal error: unable to find a suitable template
Therefore, when using an HDLM device as a book disk in Red Hat Enterprise
Linux 5, execute the following commands before installing or uninstalling a
product that uses the weak-modules script:
Before installation
# rpm -qp package-file-name-of-product
modules
Before uninstallation
# rpm -q package-file-name-of-product
modules
#
If you do not know the package file name of the product that uses the
weak-modules script, perform the procedures described in
Products That Use the Weak-Modules Script on page B-2
Products That Use the Weak-Modules Script on page
If no message is output after executing the above rpm command, the product
does not use the weak-modules script. You can install or uninstall the product
as usual.
If a message is output, the product uses the weak-modules script. Perform
the procedures described in
Script on page B-2
Script on page

Installing Products That Use the Weak-Modules Script

To install a product that uses the weak-modules script:
1 Determine which device specified in the /etc/fstab file is indicated as
.
the root directory (/).
In each of the following examples, the underlined part indicates the
device for the root directory:
Example when the boot loader is elilo and LVM is not used:
B-2
or Uninstalling Products That Use the Weak-Modules
B-6.
# cat /etc/fstab
/dev/sddlmaa2
/dev/sddlmaa1
tmpfs
devpts
sysfs
Troubleshooting Products That Use the Weak-Modules Script
Hitachi Dynamic Link Manager User Guide (for Linux(R))
#
#
--scripts | grep weak-
Installing Products That Use the Weak-Modules
/ ext3
/boot/efi vfat
/dev/shm tmpfs
/dev/pts devpts
/sys sysfs
--scripts | grep weak-
Installing
or Uninstalling
B-6.
defaults
defaults
defaults
gid=5,mode=620
defaults
1 1
0 0
0 0
0 0
0 0