Hitachi XP P9500 User Manual page 188

14 Start the host.
.
15 Execute the mount command to make sure that the SCSI device is
.
mounted.
The following shows an execution example for when GRUB is used as the
boot loader:
# mount
/dev/sda2 on / type ext2 (rw)
/dev/sda1 on /boot type ext2 (rw)
/dev/sda4 on /tmp type ext2 (rw)
/dev/sda5 on /var type ext2 (rw)
/dev/sda6 on /usr type ext2 (rw)
none on /dev/shm type tmpfs (rw)
Check the underlined section.
16 If Red Hat Enterprise Linux, SUSE LINUX Enterprise Server 10, or SUSE
.
LINUX Enterprise Server 11 is used, make sure that the SCSI device is
allocated to the swap partition.
Make sure that the SCSI device name is displayed in the Filename
column of the /proc/swaps file.
17 Perform an upgrade installation of HDLM.
.
To perform an upgrade installation of HDLM, see
Installation of HDLM on page
HDLM device. You will also need to perform step 13 if you are only
restarting the host. Note that the procedure differs depending on whether
the host is restarted after installation.
18 Execute the dlmcfgmgr utility with the -v parameter specified to check
.
the correspondence between the SCSI device and the HDLM device.
# dlmcfgmgr -v
HDevName
/dev/sddlmaa
KAPL10302-I /sbin/dlmcfgmgr completed normally.
The HDevName column indicates the HDLM device, and the Device column
indicates SCSI device.
19 Create an initial RAM disk image file for HDLM.
.
From the following, perform the procedure that corresponds to the host
OS.
¢
3-120
:
:
Management
configured
For Red Hat Enterprise Linux 6:
a Change hdlm_dracut=n defined in the /etc/opt/
.
DynamicLinkManager/hdlm.conf file to hdlm_dracut=y.
b Execute the dracut command.
.
If the initial RAM disk image file to be created already exists,
specify the -f parameter to overwrite the file.
The following shows an example of executing the command:
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Linux(R))
Performing an Upgrade
3-91, perform steps 2 to 12 to create an
Device Host
/dev/sda 0
Channel Target Lun
0 0 0